These are walls and a dungeon floor that make it possible to open the walls of your tower like a cabinet, so that you dont need to take the tower completely apart to use it. Instead, it opens like a "playset". the floors can optionally stay attatched to the swinging walls to make it easier to access the decor and miniatures inside, if so desired, or, you can open just the walls to retain the round room effect. any Fat Dragon Games floors will work with the walls, so if you want a pit trap floor, you can place a cage underneath, or a hazard, and get the full effect. or, stairs can run up from one floor to the next. While open, you can even use an extra floor piece to make a unique walkway. There are versions of walls that are normal, save for the round pin holes to be used if you desire to leave the floor connected, or there are walls divided up into two pieces so that a post stays behind to support the floor. the pins should be printed at 100% infill, as they will be under stress while in use. the walls and floor, I print at .2 with 15% infill. If you want to have only one opening level, then you will need 3 normal walls and two pins. If you want all opening levels, then you need a pin between each level. The tops will be used to hold everything in place. Alternatively, there is a clip that can be used to go from a square hole to a round hole. Get creative and find new ways to build!
Terms & Conditions for products by Fat Dragon Games can be viewed HERE.
Log In 
